HIGH PRESSURE WASHOUT - extra production, improved safety
High Pressure Washout automatically cleans all types of concrete
mixer. Faster cleanup gives 15 to 30 minutes extra production
This translates to over 5% more productivity every day, at no
extra cost. And it guarantees safety - no need to enter the
mixer. Payback is a few months in most cases.
You will have better employee morale and safety. Easily
installed rotating jets are fully automatic.
The high pressure pump unit, 1000 psi pressure at full flow
of 20 gpm to suit all concrete mixers up to 12000/8000
(10.5 yd) size. The reservoir is sized for a full wash
cycle with automatic refill and low-water pump shutoff.
Coupled with Scale-Tron’s control unit, the complete system is a
highly effective, reliable and flexible solution that
automatically cleans concrete mixers. The video at right explains how it cleans so effectively and how it can pay
for itself in a short time.
To see the LC200 head, our smallest with only 3
jets, in operation at our shipping dock,
Click here. Positioned near a 5 year
buildup of road dirt and grit, watch how each sweep of the jet
cuts a path right through it. It can do the same with the
concrete buildup on your mixer floor, paddles and walls.
A new Voeller 4
yd mixer has been in use for a week, each day a full shift, mixing SCC concrete
and has been cleaned with the washout system each day.
Note buildup on arms after the shift.
After: Three LC200 heads have done their job.
80 gallons at 900 psi as the mixer is running give a thorough cleaning cycle.
All surfaces have been covered with the LC200's rotating action, leaving the
mixer like new.
"Our High pressure Washout gives tremendous performance and it saves 1/2
hour every day. The hand cleanup gun is a powerful tool". Buzz
Morgan, Lindsay precast.
- Empower your crew by
eliminating most of the arduous end of day cleaning
- Save on cost of cleanout
Proven European washing heads have powerful high
pressure jets that rotate as well as turning for
effective mixer cleaning.
- Offset head positions
eliminate shadow behind shafts in single and
- Pump unit is built on
steel channel frame for long life.
- Reservoir capacity is 150 gallons; plenty of reserve for even the
- Reservoir and high
pressure pump are separate, allowing location in
tight corners if required.
- Hand-wash high pressure
gun and hose are included.
- Compatible with all types
of concrete mixer
except rotating drum type.
- Companion control system
includes starter and safety disconnect switch to
give manual or automatic concrete mixer cleaning.
- Nozzles can be changed to
suit different pump pressures and rates.
- Available as complete kit
or individual components, buy or lease. Pay for it
with the extra production it gives.
Pump unit and controller, specifications
2550-20 – 20 gpm pump, 1000 psi, suitable for all mixers up to 12000/8000
(10.5 yd) size. Feeds either W80 or LC200 heads in sequence through high
Dimensions: 40” W x 28”D x 60” H with
Reservoir – 150 gal cylindrical polyethylene,
28” x 56” H with high/refill/low sensors and solenoid filling
Hand wash gun – high flow, high power, heavy-duty gun, suitable
for blasting hard-to-reach deposits off mixer surfaces and
general clean-up work, supplied with 20 ft hose.
Power – specify 380 or 415V 50 Hz, 480 V or 575 V 60 Hz 3-phase
Control system – Internal PLC gives the ultimate in functionality, allowing manual operation, timed wash cycle or
remote control from batching controller. When used as
inter-batch wash, water can be timed or metered and used in